GE MULTILINK ML2400 - Manual (Page 223)

CHAPTER 13: RAPID SPANNING TREE PROTOCOL RAPID SPANNING TREE PROTOCOL
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 13–15
The sequence of commands for enabling ring-only mode is shown in the following
example:
Example 13-5: Configuring smart RSTP, ring-only mode
ML2400#
rstp
ML2400(rstp)##
rstp enable
Successfully set the RSTP status
ML2400(rstp)##
romode show
RO-MODE status : Disabled
RO-MODE set on ports : NONE
ML2400(rstp)##
romode add port=1,2
Added Ports: 1,2
ML2400(rstp)##
romode enable
RSTP Ring Only Mode Enabled.
ML2400(rstp)##
romode show
RO-MODE status : Enabled
RO-MODE set on ports : 1,2
ML2400(rstp)##
romode disable
RSTP Ring Only Mode Disabled.
ML2400(rstp)##
romode show
RO-MODE status : Disabled
RO-MODE set on ports : 1,2
ML2400(rstp)##
romode del port=1,2
Deleted Ports: 1,2
ML2400(rstp)##
romode show
RO-MODE status : Disabled
RO-MODE set on ports : NONE
ML2400(rstp)##