GE MULTILINK ML2400 - Manual (Page 230)

13–22 MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
RAPID SPANNING TREE PROTOCOL CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Z Select the Configuration > RSTP > Bridge RSTP menu as shown
below.
Z Click the Edit button to configure RSTP.
Z Once in Edit mode, change the Status to Enable.
Z Save Configuration.
To reset RSTP back to normal mode, select “Normal RSTP” for the Protocol setting. Save the
configuration by clicking on the
icon.
ENABLE STATUS...
...THEN SAVE