Motorola APS120 - Manual (Page 15)

2 • 5
4. Connect the PCI interface. To send the pre-programmed database,
refer to section 3.6.3, Sending the Database.
5. If you are connecting a modem, go to section 2.5, Connecting the Modem n o w.
If not, go on to Step 6.
6. Connect the output plug from the power supply to the 9V AC jack on the
unit. Plug the power supply into a 110V AC outlet. The power LED on the
unit should be lit.
F i g u re 2-1: Contact Closure to Pin Assignments
2.5
C o n n e c t i n g th e M o d e m
Verify dipswitch settings on the modem. 1-4-6-7 UP. 2-3-5-8- DOWN.
To set up the modem, do the following:
1. Make sure that both the APS Custom and the modem are turned off.
2. Connect the modem to the PCI/Modem port on the APS Custom unit. Use
the modem cable supplied with the APS Custom.
3. Connect the modem to a phone line with a telephone cord. Note the
number for that phone line.
4. Connect the modem's power supply to the modem and plug it in.
5. Turn on the modem.
6. Connect the output plug from the power supply to the 9V AC jack on the
unit. Plug the power supply into a 110V AC outlet. The power LED on the unit
should be lit. The IN USE Program LEDs will flash several times and then stop.
The APS Custom will automatically detect the modem and initialize it. The APS Custom is
now ready for remote access.
Cable
Pin Function Color Code
1 Contact 1 Brown
2 Contact 2 Red
3 Contact 3 Orange
4 Contact 4 Yellow
5 Contact 5 Green
6 Contact 6 Blue
7 Contact 7 Purple
8 Contact 8 Grey
9 Common White