Motorola APS120 - Manual (Page 22)

3. Enter the APS 120/360 Access password you want to use in the New APS
120/360 Access field. The Access password must be 8 characters in length
and it is case sensitive. Click the OK button and the APS Custom PCI program
will return to the PCI Main Dialog window.
4. Connect to the APS Custom unit. Once connected, click the Send Database
button to send the database. The Access Password in the APS Custom unit will
not be changed unless the database is sent. Once the database has been sent
successfully, the APS Custom unit's Access Password will be set to the new
password. The APS Custom PCI program will then update the Current APS
120/360 Access Password field to match the New APS 120/360 Access
Password field.
5. Click the Disconnect button and the Access password change process is
complete. The Current APS 120/360 Access password now matches the New
APS 120/360 Access password in the System Data screen.
The PBX Parameters option enables you to specify how the APS Custom interfaces with
the PBX to perform call transfers, parking, and interface with the voice mail system. PBX
timing parameters are also specified on this screen.
Access the PBX Parameters screen (Figure 3-4) by selecting the PBX Parameters option
f rom the PCI Main Dialog screen (Figure 3-1). When the parameters are entered, select
OK to close the screen, or Next to move to the Port Data scre e n .
WARNING: The PBX Parameters screen displays the PBX Extension
Length specified during database creation. PBX Extension
Length can be specified ONLY during the initial database
setup. If entered incorre c t l y, or if future modifications are
needed, the database must be deleted and re c re a t e d .
3.2.3 Se t t i n g P B X Pa r am e te r s
!
3 • 6