MicroNet Technology SP1659P - Manual (Page 21)

Interval is used to set the update frequency. Default update time is 3 seconds.
Parameter description:
y Tx Byte: Total transmitted bytes.
y Rx Byte: Total received bytes.
y Tx Packet: The counting number of the packet transmitted.
y Rx Packet: The counting number of the packet received.
y Tx Collision: Number of collisions transmitting frames experienced.
y Rx Error Packet: Number of bad packets received.
3.4.4 Detailed Counter
The function of Detail Counter collects any information and provides the counting about the traffic of the port,
no matter the packet is good or bad. As below, the window can show only one port counter information at the
same time. To see another port’s counter, you have to pull down the list of Select, then you will see the figures
displayed about the port you had chosen. Each data field has 12-digit long. If the counting is overflow, the
counter will be reset and restart counting. The data is updated every time interval defined by the user. The
valid range is 3 to 10 seconds. The Refresh Interval is used to set the update frequency. Default update time is
3 seconds.
20