MicroNet Technology SP1659P - Manual (Page 69)

11. ip
12. help
13. ip
14. history
SP1659P(ip)# history 3
Command history:
13. ip
14. history
15. history 3
4.2.5 restore default
Syntax: restore default
Description:
To restore the startup configuration as factory default configuration. If restoring default successfully, the CLI
would prompt if reboot immediately or not. If you press Y or y, the system would reboot immediately; others
would be back to the CLI system. After restoring default configuration, all the changes in the startup
configuration would be lost. After rebooting, the entire startup configuration would reset to factory default.
Argument: None
Possible value: None
Example:
SP1659P# restore default
Restoring ...
Restore Default Configuration Successfully
Press any key to reboot system.
4.2.6 restore user
Syntax: restore user
Description:
To restore the startup configuration as user defined configuration. If restoring default successfully, the CLI
would prompt if reboot immediately or not. If you press Y or y, the system would reboot immediately; others
would back to the CLI system. After restoring user-defined configuration, all the changes in the startup
configuration would be lost. After rebooting, the entire startup configuration would replace as user defined one.
Argument: None
Possible value: None
Example:
SP1659P# restore user
Restoring ...
Restore User Configuration Successfully
Press any key to reboot system.
4.2.7 save start
Syntax: save start
Description:
Save the current configuration as the start one. When you enter this command, the CLI would save your
current configuration into the non-volatile FLASH. If you want the configuration still works after rebooting, save
the configuration using the command ‘save stat’.
Argument: None.
68