MITSUBISHI ELECTRIC WD-62327 - Manual (Page 12)

12 13
Separate UHF and VHF Antennas
(Figure 1)
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT-A on the TV back
panel.
UHF/VHF combiners are not provided with the TV. They
are available at most electronic stores.
Note: This TV will only be able to provide an
analog signal through ANT-A on the
TV back panel.
See page 5 for Outdoor Antenna Grounding
information.
��������
�������
��������
���� ����
��������������
�������������
����������������
������������
���������������
����������
�������
��������
���������������
���
���
�������������������������������
�� � � � � � �� �
�� � �
���
�
�
Figure 1. Connecting separate UHF and VHF antennas.
������������
���������
��������������������������
��������������������
������
�������������
�
�
�
�������������������������������
�� � � � � � �� �
�� � �
���
Figure 2. Connecting twin lead antenna, coaxial lead
antenna, or wall outlet cable.
Twin Lead Antenna, Coaxial Lead
Antenna, or Wall Outlet Cable
(Figure 2)
For antenna with twin flat leads:
1. Connect the 300 Ohm twin leads to the transformer.
2. Push the 75 Ohm side of the transformer onto
ANT-A on the TV back panel.
300 Ohm to 75 Ohm matching transformers are not
provided with the TV. They are available at most
electronic stores.
For cable or antenna with coaxial lead:
3. Connect the incoming cable to ANT-A on the TV
back panel.
Note: This TV will only be able to provide an
analog signal through ANT-A on the TV back
panel.
See page 5 for Outdoor Antenna Grounding
information.
Connecting an Antenna or Wall Outlet Cable
Additional connection cables are not
provided with the TV. They should be
available at most electronic stores.
Mitsubishi strongly recommends against using
antennas with twin flat leads. Twin flat lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.