MITSUBISHI ELECTRIC WD-62327 - Manual (Page 25)

24 25
When set to TV, the PLAY, STOP, REW/
REV, and FF/FWD buttons will operate
the VCR after the VCR codes have
been properly programmed into the
remote control.
Figure 3. Programming the remote to control your VCR.
POWER
Code to enter:
To reset to default code, enter 000
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnavox
Panasonic
RCA
Sony
Toshiba
001, 002
020, 043, 065
030, 054
043, 044, 051
041, 042, 043
020, 053, 065
048, 049, 050
021
If your
VCR
code is not
listed here,
please see
page 61
for a
complete
listing.
VCR Codes
1. 2.
3.
TV AUDIO
CABLE/DBS/DTV DVD VCR
Use of the Remote Control with Other A/V Products
Programming the Remote Control to Use with Other Brands of Audio and Video
Products:
(Figures 1-4 this page, Figure 5, following page)
1. Move the slide switch at the top of the remote to the product you want to control.
2. Press and hold the POWER button on the remote control.
3. Enter the first three digit code listed for your equipment, and then release the POWER button on the remote
control.
4. Point the remote control to the equipment and press the POWER button.
Note: If the equipment responds,the remote control is properly programmed to operate the equipment.
If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3.
If you cannot turn the cable box ON
by pressing POWER, try pressing
CHANNEL or the number buttons.
Figure 1. Programming the remote to control your
cable box.
POWER
Code to enter:
To reset to default code, enter 000
Cable box brand
General Instruments/
Jerrold
Motorola
Oak
Pioneer
Scientific Atlanta
Zenith
119, 120, 121, 122,123,
124
125, 126, 127
139, 137, 102
101, 116
112, 113
117, 100
If your
cable box
code is not
listed here,
please see
page 60
for a
complete
listing.
Cable Box Codes
1. 2.
3.
TV AUDIO
CABLE/DBS/DTV DVD VCR
Figure 2. Programming the remote to control your
satellite receiver.
POWER
Code to enter:
To reset to default code, enter 000
Satellite brand
Mitsubishi DTV - DBS
DishNetwork
Hughes - DBS
Panasonic - DBS
RCA - DBS
Sony - DBS
Toshiba-DBS
006
175
173
174
176
177
170, 173, 189, 190, 191
If your
satellite
receiver
code is not
listed here,
please see
page 61 for
a complete
listing.
Satellite Receiver Codes
1.
3.
2.
TV AUDIO
CABLE/DBS/DTV DVD VCR
Figure 4. Programming the remote to control your DVD
or LDP.
POWER
Code to enter:
To reset to default code, enter 000
DVD/LDP brand
Mitsubishi
JVC
Panasonic
Philips
Pioneer DVD
Samsung
Sony
Toshiba
003
257
250
258, 253, 272
252
261
254
253
If your
DVD
code is not
listed here,
please see
page 60
for a
complete
listing.
DVD Player Codes
1. 2.
3.
TV AUDIO
CABLE/DBS/DTV DVD VCR