MITSUBISHI ELECTRIC WD-62327 User Manual
Page 26
26
27
If the slide switch is set to TV when you enter
an A/V receiver code, VOLUME and MUTE will
control the A/V receiver rather than the TV. To
return volume and mute control to the TV, set
the slide switch to TV, press and hold POWER
and enter 000.
Figure 5. Programming the remote to control your
A/V receiver.
Use of the Remote Control with Other A/V Products, continued
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. If you enter a code from the A/V Receiver
Codes chart while the slide switch is set to TV, the
volume and mute functions change to match the A/V
receiver. This is useful when using an A/V receiver
with the TV all the time. In all other cases, only one
of the below devices is allowed for each slide switch
position.
TV position:
•
TV
• A/V receiver (volume and mute only)
Cable/DBS/DTV position:
• Cable box
• Satellite receiver
• DTV receiver
VCR position:
• VCR
DVD position:
• DVD
• LD Player
Audio position:
• A/V receiver
• Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio
position may be used in conjunction with select
Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player
power cord into a switched outlet on the back of your
A/V receiver. Pressing the POWER button turns On
the A/V receiver, along with the CD player. In the
audio position, for some CD players, the transport
controls (FF, Play, Rew, etc.) operate the CD player.
POWER
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
and/or CD player
Denon
Harman Kardon
JVC
Kenwood
Marantz
Onkyo
Pioneer
Sony
Technics
Yamaha
010, 015, 011, 012,
013, 014
234, 235, 236, 245,
246, 359
215, 223, 242
233, 232
208, 200
224, 350
209, 214, 240, 247
205, 207
222, 249
218, 219, 221
202, 201, 243, 244
If your
audio
code is not
listed here,
please see
page 60
for a
complete
listing.
A/V Receiver Codes
1.
3.
2.
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
Some manufacturers may change their
products, or they may use more than one
remote control system. If this is the case,
your remote control may not be able to
operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.