MITSUBISHI ELECTRIC WD-62327 - Manual (Page 13)

12 13
Figure 3. Connecting the cable box.
���
���������
�������������������������������
��
��������������
�
�������������������������������
�� � � � � � �� �
�� � �
���
�
�
��������������
��
���
�������
��������������
�������������������������������
�� � � � � � �� �
�� � �
���
�
�
� �
��������� �������� ���������
�����
�������
�
�
�
�
�
� �
�
Figure 4. Connecting the VCR with antenna or wall
outlet cable.
Connecting an Antenna to a Cable Box or VCR
Antenna to a Cable Box
(Figure 3)
1. Connect the incoming cable to ANT-A on the TV
back panel.
Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to IN on
the cable box back panel.
3. One from OUT on the cable box back panel to ANT-
B on the TV back panel.
Note: If your cable box has separate audio/video
outputs, connect the audio as shown in
Figure 6, page 14.
Antenna to a VCR
(Figure 4)
1. Connect the incoming cable to ANT-A on the TV
back panel.
Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to
ANTENNA IN on the VCR back panel.
3. One from VCR back panel ANTENNA OUT to ANT-
B on the TV back panel.
Note: If your VCR has separate audio/video
outputs, connect the audio as shown in
Figure 6, page 14.
Note: When the Energy Mode is set to Low, the
VCR may not record programs when the TV
is off.
Note: For digital cable boxes, refer to your Digital
Cable Box owner’s guide for instructions on
optimal connections to this TV.