MITSUBISHI ELECTRIC WD-62327 - Manual (Page 24)

24 25
Remote Control Functions: Channel Selection, Sleep Timer
Channel Selection
• Enter three numbers (for channel 2, press 002).
or
• Press the channel number and ENTER (for
channel 2, press 2, then ENTER).
or
• Enter the channel number and wait four seconds
(without pressing ENTER). The TV will change
automatically.
Sleep Timer
(Figure 3 & 4)
Setting the Sleep Timer:
• Press SLEEP on the remote control.
• A message indicating the length of time the
sleep timer is to be set appears on the
TV screen.
• Each press of SLEEP will increase the time
displayed by 30 minutes, until the maximum
value of 120 minutes is reached.
• After 5 seconds of inactivity, the message will
disappear.
• Press SLEEP to view the remaining time before
the timer turns the TV off.
Canceling the Sleep Timer:
• Press the SLEEP button to display the
on-screen message.
• Press SLEEP repeatedly until OFF is displayed.
After 5 seconds of inactivity, the message will
disappear.
Sleep: 30 min.
Figure 4. On-screen display for sleep timer
Note: Use the CANCEL button for digital
subchannel (-) selection in the
CABLE/DBS/DTV layer.
Figure 3. Sleep button on remote control
POWER
3
6
9
QV
1
7
SQV
4
SLEEP
2
5
8
0
TV AUDIO
CABLE/DBS/DTV DVD
VCR