MicroNet Technology IP TELEPHONY GATEWAY SP5052 - Manual (Page 26)

26
5.12 [pppoe]
Display PPPoE related information.
PPPoE device information and configuration
Usage:
pppoe [-print]|[-open]|[-close]
pppoe [-dev on/off][-id username][-pwd password]
-print Display PPPoE device information.
-dev Enable(=1) or Disable(=0) device.
-open Open PPPoE connection.
-close Disconnect PPPoE connection.
-id Connection user name.
-pwd Connection password.
-reboot Reboot after remote host disconnection.
Paremeter Usage:
-print
print PPPoE status.
-dev Enable PPPoE Dial-up function
-open Open the connection
-close Close the connection
-id Input the User name ID provided by ISP
-pwd Input the User name password provided by ISP
-reboot Reboot the PPPoE connection.
5.13 [sysconf] command
This command displays the system information and configuration.
usr/config$ sysconf
System information and configuration
Usage:
Sysconf [-service type] [-plan digits] [-2nddial flag]
[-keypad dtmf] [-ringdet method] [-callalive flag]
[-port s1 s2 s3 s4 ]
[-seizure mode] [-2nddial switch]
[-drule [in_filter str1] [in_drop str2] [in_insert str3]
[out_filter str4] [out_drop str5] [out_insert str6]]
[-askpin f] [-pincode [set1 pin1] [set2 pin2] [set3 pin3] [set4 pin4]]
sysconf -print
-print Display system overall information and configuration.
-service Specify gateway service type.
(0: Dial in service,2: HotLine/LineToLine service.)
-ringdet Specify gateway ring detect method. (0:For 1st hardware
version,
1:For 2st hardware version.
-plan Number of digits for dial plan. (any positive number.)
-port Enable/Disable individual port.