MicroNet Technology IP TELEPHONY GATEWAY SP5052 - Manual (Page 38)

38
-enable Enable PSTN Grouping
-disable Disable PSTN Grouping
-number Set number of divided groups
-pattern
Set number of members in each group
-e164 Set E.164 number for each group
Example:
group -print
group -enable
group -disable
group -number 2 -pattern 3 3 -e164 01 02
group -pattern 3 1 -e164 100 200
group -e164 11 22
Parameter Usages:
- print display current grouping information
- enable enable grouping function
- disable disable grouping function
- number set how many groups will be divided
- pattern set how many members in each group
- e164 set e164 of each group
For example, if users need to divide VoIP FXO gateway into L1 in the 1 st
group, and L2 in the 2 nd group, and have them register to gatekeeper
separately (e164=100 for 1 st group; e164=200 for 2 nd group), they have to use
the following command:
usr/config$ group –pattern 1 3 –e164 100 200
Note: GROUP function is effective only in gatekeeper mode.
5.21 [bureau] command
Type bureau to display the command usage.
usr/config$ bureau
Bureau line setting information and configuration
Usage:
bureau [-pstn number] [-hold used] [-table [Port DestIP TELnum]]
bureau -print
-print Display Bureau line information and configuration.
-pstn PSTN number (per port basis). This number is used to
display
as a caller ID when the caller ID is not available.
The maximum digit length is 32.
-hold Specify the hold tone generation (using PCM file). (On/Off)
Setting value (On=1, Off=0).