MicroNet Technology IP TELEPHONY GATEWAY SP5052 User Manual
Page 39
39
-table
Set Hot line/Line To Line information. (Port range: 1~2)
Note:
Hotline feature should be used together with:
$sysconf -service 2 (HotLine service)
$sysconf
-2nddial 0 (2nddial off)
$h323
-mode
1
(peer-to-peer
mode)
Line To Line feature should be used together with:
$sysconf
-service
2
(HotLine service/Line To Line )
$sysconf
-2nddial 1 (2nddial on)
$h323
-mode
1
(peer-to-peer
mode)
Example:
bureau -pstn 2011 2012
bureau -table 1 192.168.4.69 628 2 192.168.4.200 9992
Parameter Usages:
- print: display bureau line information and configuration.
usr/config$ bureau -print
Bureau line setting relate information
PSTN number
: 2011 2012 2013 2014 2015 2016
Hold tone generation : On
Hot line / Line to Line table
==================================================
Port Destination Address Remote TEL/CHANNEL
--------------------------------------------------------------------------------------------------
1
192.168.4.69
628
2
192.168.4.69
628
==================================================
- pstn
PSTN number (per port basis). This number is used to display
as a caller ID when the caller ID is not available. The maximum
digit length is 32.
- hold
while the terminals support H.450 hold function, the VoIP FXO
gateway will play the hold tone to PSTN side.
- table
Set Hot line/LineToLine destination IP and e164 numbers
information.
Note:
1. HotLine and LineToLine functions are using the same table.
2. In HotLine service, user have to set line No. prepared to dial out; in
LineToLine service ,user have to set port No. For example, if user set
bureau –table 1 192.168.4.69 628 in hotline service, after user dial in VoIP
FXO gateway port 1, VoIP FXO gateway will direct dial to 192.168.4.69
and dial 628 to PSTN side, then Phone 628 will ring. User will hear ring
back tone. If user set bureau –table 1 192.168.4.69 1 in LineToLine service,
after user dial in VoIP FXO gateway port 1 , VoIP FXO gateway will direct
dial to 192.168.4.69 port 1,user will hear dial tone, then user can dial out
No. to PSTN side.