MicroNet Technology IP TELEPHONY GATEWAY SP5052 - Manual (Page 32)

32
-e164 e164 number, which is registered as phone number in
gatekeeper.
-alias
h323 ID, a identification in h323 world for other parties’
recognition. The field might be used as a key of authorization or
accounting in some VoIP application. It is recommended to assign
a special name, or it might conflict with other devices.
-gkdis
Switch ON or OFF of gatekeeper discovery function (1 = ON; 0 =
OFF). When it’s ON, VoIP FXO gateway will send GRQ with GK
ID to default gatekeeper. If the GK ID didn’t matched, GW will
send GRQ with GK ID in multicast.
-rtp
to allocate RTP port range—NOT RECOMMENDED. This may be
used when RTP port range conflicts with firewall policy.
-h245
to assign h.245 port number, NOT AVAILABLE for the moment.
-ttl
to set timer for TTL(Time To Live). VoIP FXO gateway would send
RRQ, with keepAlive, to gatekeeper periodically according to TTL
timer.
-gkfind
gatekeeper finding port. Port number, which VoIP FXO gateway
uses it to discover a gatekeeper. Default value is 1718.
-gwtype
to set VoIP FXO gateway register mode as terminal or gateway. 0
is for terminal and 1 is for gateway. If set VoIP FXO gateway as
terminal mode, it must be set sysconf –2nddial 1(refer to 5.12).
-ras
to set default gatekeeper RAS port number. Default value, 1719,
is well-known port for RAS communication.
-range
to allocate dynamic port range, which VoIP FXO gateway may
use.
-respto
response timeout. Max waiting time for 1st response to a new call
(1~200).
-connto
connection timeout. Max waiting time for call establishment after
receiving 1st response of a new call (1~20000).
5.15 [gk] command
This command is to configure embedded simple gatekeeper parameters. If
user doesn’t have a gatekeeper or Micronet Call Manager, VoIP FXO
gateway provides a simple embedded gatekeeper for up to 10 endpoints.
usr/config$ gk
Gatekeeper information and configuration