MicroNet Technology IP TELEPHONY GATEWAY SP5052 - Manual (Page 47)

47
Step 3. Start configure
Most of all commands displayed in console / telnet are transfer to web interface.
The most important commands are Network Interface, H323 Information, Commit
Data and Reboot System. The method is as the same as command mode.
1.1 Network Interface
z IP Address: Set IP Address
z Subnet Mask: Set the Subnet Mask
z Default routing gateway: Set Default routing gateway
z DHCP: Enable / Disable to DHCP mode
z SNTP: Enable / Disable the Simple Network Time Protocol
z SNTP Server Address: Set SNTP Server Address
z GMT: Set time zone for SNTP Server time
z IP Sharing: Enable it if behind IP Sharing router
z IP Sharing Server Address: Set WAN IP Address of IP Sharing
Server router if it is a fixed one.
Note:
If the WAN IP Address of IP Sharing Server router is not a fixed one, it is
not necessary to input any values.
If it is behind the dynamic WAN IP Address situation please configure as
GK mode and select Micronet Call Manager as proxy server.