MicroNet Technology IP TELEPHONY GATEWAY SP5052 - Manual (Page 36)

36
-rtptype configure TOS type of RTP packets from 0 to 7
-rtcptype configure TOS type of RTCP packets from 0 to 7
-sigdelay configure signaling packets as normal delay or low delay
-rtpdelay configure RTP packets as normal delay or low delay
-rtcpdelay configure RTCP packets as normal delay or low delay
-sigthruput configure signaling packets as normal throughput or high
throughput
-rtpthruput configure RTP packets as normal throughput or high throughput
-rtcpthruput configure RTCP packets as normal throughput or high
throughput
-sigreliab configure signaling packets as normal reliability or high reliability
-rtpreliab configure RTP packets as normal reliability or high reliability
-rtcpreliab configure RTCP packets as normal reliability or high reliability
Note:
Users should be aware that TOS is effective only when network devices (for
ex: router, switch.. etc.) support TOS.
5.18 [tone] command
Tone of VoIP FXO gateway is configurable if the bureau line is connected to
PABX or PSTN. Users can refer to “greetrd” command for tone recording and
analysis. Sometimes the frequencies might shift from standard level. In such a
situation, users have to adjust the tone value manually using this command.
usr/config$ tone
Setup of call progress tones
Usage:
tone -toneX LowFreq HighFreq LowFreqLevel HighFreqLevel TOn1 TOff1
TOn2 TOff2
tone -print
Note:
toneX has the following possibility:
busy1 busy2 reorder1 reorder2 ringtone1 ringtone2 dialtone
Example:
tone -busy1 400 0 8 0 50 50 0 0
tone -dialtone 400 0 19 0 25 25 0 0
5.19 [support] command
This command provides some extra functions that might be needed by users.
usr/config$ support
Special Voice function support manipulation
Usage:
support[-tunnel enable]
support -print