Multiquip MQ Power Whisperwatt 60HZ Generator DCA150USJ2 - Manual (Page 34)

page 34 — DCa150USJ2 60 hz generator • operation anD partS manUal — rev. #0 (08/22/11)
diagnOstic display
gloSSarY (troubleshooting information)
CanBUS FailUre
Diagnostic Display has not received any CAN messages for at least 30 seconds.
NO DATA
Diagnostic Display has not received the particular message being displayed for at least 5 seconds.
NOT SUPPORTED
Diagnostic Display has received a message from the ECU stating the displayed message is not supported
DATA ERROR
Diagnostic Display has received an error message from the ECU for the displayed message.
emptY
No parameter selected for this 4- UP quadrant.
Wait to Start preheating
This is a message from the engine indicating it is in a preheating cycle.
Wait until this message clears before starting the engine.
timeoUt eCU not reSponDing
The ECU did not respond to the PowerView request.
NO GAGE DATA
The Diagnostic Display has no record of connected gages to the RS485 bus.
DiSplaY not viSiBle
Press and hold the “Menu” button for approximately 3 seconds.