Multiquip MQ Power Whisperwatt 60HZ Generator DCA150USJ2 - Manual (Page 54)

page 54 — DCa150USJ2 60 hz generator • operation anD partS manUal — rev. #0 (08/22/11)
Maintenance
If the engine is operating in very dusty or dry grass
conditions, a clogged air cleaner will result. This can lead to
a loss of power, excessive carbon buildup in the combustion
chamber and high fuel consumption. Change air cleaner
more frequently if these conditions exists.
FUel aDDition
Add diesel fuel (the grade may vary according to season
and locations).
Removing Water from the Fuel Tank
After prolonged use, water and other impurities accumulate
in the bottom of the tank. Occasionally inspect the fuel
tank for water contamination and drain the contents if
required.
During cold weather, the more empty volume inside the
tank, the easier it is for water to condense. This can be
reduced by keeping the tank full with diesel fuel.
Cleaning inside the Fuel tank
If necessary, drain the fuel inside the fuel tank completely.
Using a spray washer (Figure 58) wash out any deposits
or debris that have accumulated inside the fuel tank.
Figure 58. Fuel Tank Cleaning
FUel tanK inSpeCtion
In addition to cleaning the fuel tank, the following
components should be inspected for wear:
„ Rubber Suspension — look for signs of wear or
deformity due to contact with oil. Replace the rubber
suspension if necessary.
„ Fuel Hoses — inspect nylon and rubber hoses for signs
of wear, deterioration and hardening.
„ Fuel tank lining — inspect the fuel tank lining for signs
of excessive amounts of oil or other foreign matter.
Replacing Fuel Filter
„ Replace the fuel filter cartridge with new one every 500
hours or so.
„ Loosen the drain plug at the lower top of the fuel filter.
Drain the fuel in the fuel body together with the mixed
water. DO NOT spill the fuel during disassembly.
„ Vent any air
air removal
If air enters the fuel injection system of a diesel engine,
starting becomes impossible. After running out of fuel,
or after disassembling the fuel system, bleed the system
according to the following procedure. See the JOHN
Deere engine manual for details.
To restart after running out of fuel, turn the switch to the
“ON” position for 15-30 seconds. Try again, if needed.