M54e2 quick installation – Micronics M54E2 PCI/EISA User Manual
Page 10
Section 1: Introduction
M54E2 System Board Manual
M54E2 Quick Installation
We know that many experienced people prefer to read as little of the docu-
mentation as possible. If this sounds like you, here’s the short form:
1.
Make backup copies of your installation and configuration diskettes.
2.
Ground yourself to prevent damaging static discharge, then remove the
M54E2 from its packaging.
3.
Configure and verify the system board’s jumper settings. (See Jumper
Settings in Chapter 2).
4.
Install the CPU and the system memory (Chapter 3).
5.
Install the motherboard into the chassis and make all necessary
case connections.
6.
Install any ISA, PCI and EISA add-on peripherals (Chapter 3).
7.
Turn the computer on and press the <F2> key when you see the screen
below:
1.3
Figure 1-1: Power-Up Screen