Installing a plug & play peripheral card – Micronics M54E2 PCI/EISA User Manual
Page 29
M54E2 System Board Manual
Section 3: Installing the M54E2
Installing a Plug & Play Peripheral Card
Micronics EISA slots accommodate all ISA Plug & Play peripherals that
meet the Plug and Play standard. Complete the following steps to install a
Plug and Play card:
1.
Turn the computer system off and remove its cover. Note the slot
number where you choose to install the Plug and Play card. You
will need this information when you run the EISA configuration
utility.
2.
Choose an unused EISA slot and remove the slot cover.
3.
Insert the card with the bottom edge level to the slot. Never insert
the card at an angle!
4.
Carefully push the card straight down, making sure the card is fully
inserted.
5.
Replace the screw which holds the card into place.
6.
Replace the computer cover.
7.
Refer to the card’s documentation for additional instructions regarding
installation and software drivers.
8.
Run the EISA configuration utility discussed in Chapter 5.
Figure 3-5: Installing a Plug & Play Card
3-10