Micronics M54E2 PCI/EISA - Manual (Page 39)

Section 4: BIOS Setup Utility
M54E2 System Board Manual
COM Port B
COM Port B may be set for COM2 (default), COM1, COM3, COM4 or may
be disabled.
LPT Port
The parallel port may be set for 378-IRQ7, 278-IRQ7 or Disabled (default).
LPT Mode
The parallel port mode may be set for output mode bidirectional (default),
Enhanced Parallel Port (EPP), Extended Capabilities Port (ECP), or Output
Only.
Diskette Controller
The floppy disk controller may be enabled or disabled.
ISA IDE Controller
Enables the ISA IDE adapter. The ISA IDE controller may be set for Primary,
Secondary or Disabled (default).
Large Disk DOS Compatibility
If you are using a DOS operating system (MS-DOS, DR-DOS, or PC-DOS),
set to DOS (default). If you are using anything else, set to OTHER.
Memory Gap
When enabled, this category removes the memory between 15 and 16 mega-
bytes from the system. This one megabyte hole will allow some ISA network
cards to map into this memory space. Banyon network cards require this
feature. Enable this feature only if needed. The default is Disabled.
Plug and Play O/S
This selection, when set to Yes, allows the system to work with a Plug and
Play operating system such as Windows 95. The default setting is No.
Reset Configuration Data
Select Yes to clear the system configuration data. The default setting is No.
4 - 1 0