Micronics M54E2 PCI/EISA - Manual (Page 41)

Section 4: BIOS Setup Utility
M54E2 System Board Manual
4 - 1 2
Figure 4-8 Supervisor Password Submenu
Type the password and press the <Enter> key. Retype the password and press
the <Enter> key again. Write down the password somewhere safe so it will
not be forgotten. The password may be disabled by setting the new password
to nothing (pressing the <Enter> key without first typing a password).
WARNING: If you forget the Supervisor Password, it cannot be disabled
without discharging the CMOS.
Set User Password
Follow the same procedure used to set the Supervisor Password.
NOTE: When a password has been entered, it is saved immediately. All
other changes may still be discarded (see Exit Screen).
Password on Boot
When enabled, the system will require a password to be entered upon boot.
Either the Supervisor or User Password may be entered.
Diskette Access
This category allows floppy disk access with an option of the Supervisor or
User. Selecting Supervisor gives floppy disk access to the supervisor only.