Micronics M54E2 PCI/EISA - Manual (Page 47)

Section 5: EISA Utility
M54E2 System Board Manual
5-4
Step 2: Add or Remove Boards
When you select Step 2, the utility scans and locates the EISA boards
installed. This section allows you to add or remove any EISA, PCI, and ISA
Plug and Play peripherals. Beyond physically adding or removing the boards,
it is important that you run this utility in order for your system to run prop-
erly.
When you select “Step 2: Add or Remove Boards,” the following screen
(Figure 5-3) will appear.
Figure 5-3 Add or Remove Boards Screen
Press <Insert> to add the boards that could not be detected or boards you plan
to install. After you press the <Insert> key, the following screen (Figure 5-4)
will appear.
You will need to have the configuration disks that came with each of the add-
on cards you are installing. Insert the configuration disk for the peripheral
you are installing and press <Enter>.