Advanced use, Changing or programming settings, Dvanced – Motorola RG2200 User Manual
Page 33
33
A
DVANCED
U
SE
You will need the information in this section if you want to change the default settings that were set up by your NSP or
reprogram your remote control because it is not working correctly.
Note:
Your NSP programs your RG2200 and remote control when your system is first connected. The NSP also programs
the same Gateway ID (this is the ID of your RG2200) into all the remote controls in your home. If there is more than one
RG2200 in your home, your NSP programs the Gateway ID into each remote control that communicates with a specific
RG2200.
C
HANGING
OR
P
ROGRAMMING
S
ETTINGS
By using the remote control, the RG2200 front-panel buttons, and on-screen menus, you can perform the following tasks.
•
Determine the Gateway ID
•
Set the Gateway ID
•
Determine the Remote Control ID
•
Set the Remote Control ID
•
Determine the remote control Operating Mode
•
Set the remote control Operating Mode
•
Program TV Code
•
Verify the TV RF channel
•
Set the Display Language
•
Set up Secondary Audio
•
Set the EADS (Emergency Alert Device Support) display