Motorola RG2200 User Manual
Page 70
70
No picture
TV or RG2200 may not be acti-
vated.
Refer to
Cable signal may not be reach-
ing your home.
Make sure all cables are connected properly and that your TV is tuned to the correct RF
channel (for example 6,7, or 13) for the TV you are using (TV-1, TV-2, or TV-3). If the
baseband video output on the RG2200 is connected to the VIDEO IN input on the TV,
make sure the TV is set to the correct video input.
VCR may be set incorrectly.
Check to see how the VCR is connected to the RG2200. If the baseband video output
on the RG2200 is connected to the VCR, the VCR must be ON and programmed to
VIDEO IN.
Make sure VCR/TV is set to TV.
Make sure the TV is set to the correct TV or video input.
No picture
Your RG2200 has recently
received a software download.
Sometimes after a download the
system fails to operate. You may
need to restart your RG2200.
To restart your RG2200, press and hold down the power button on the front panel for 5
seconds.
Picture is distorted
Coaxial cable is disconnected or
loose.
Reconnect or tighten the cable.
Blue or black TV screen
No video supplied to TV.
If VCR is connected using RCA jacks, VCR must be ON to provide picture.
Snowy picture on all TVs
VCR is on at this location and TV
is on wrong channel.
Call your NSP to reset your RF channel.
TV is on wrong channel for
Source.
Call your NSP to reset your RF channel.
Only one stereo speaker
has sound
Audio connections are loose.
Reconnect audio connections.
Check to make sure that no wires are frayed and no plugs are bent or broken.
Problem
Possible Cause
Try This