Motorola RG2200 - Manual (Page 37)

37
S ETTING THE G ATEWAY ID
Depending upon the model of the remote control, instructions are as follows.
If you entered the Gateway ID correctly, the LED blinks several times. If the value was not entered successfully, the LED
goes off and the remote control returns to normal operation. Repeat the steps above to try again. See
”Determining the
Gateway ID” on page 34 to verify the Gateway ID.
SRC-300 SRC-200
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the REC key. The LED stops blinking at this point
and stays on solid.
3. Press the B key. The remote is now in programming
mode. You can set the GATEWAY ID.
4. Enter the 3-digit code assigned to your RG2200. The
valid range is 004 - 999 for SRC-300s in native mode.
For SRC-300s in SRC-200 Compatibility mode, the
range is 004 - 255. Enter a number with 3-digits, even if
it contains leading zeroes. Examples of valid values are:
009, 012, 354, or 988.
1. Press the B key and hold it down until the LED at the
top of the remote flashes rapidly.
2. Release the B key.
3. Enter the following three key sequence: 7-8-9. The
remote is now in programming mode. You can set the
GATEWAY ID.
4. Enter the 3-digit code assigned to your RG2200. The
valid range is 004 - 255. You must enter a number with
3-digits, even if it contains leading zeroes. Examples of
valid values are: 009, 012, 124, or 255.