Motorola RG2200 - Manual (Page 44)

44
V ERIFYING THE TV C ODES
To playback the TV code:
For example, code 130 would show as the following:
<pause> <long blink> <off> (represents 1)
<pause> <long blink> <long blink> <long blink><off> (represents 3)
<pause> <short burst of flickering blinks> <off> (represents 0)
SRC-300 SRC-200
1. Press the LED key and hold it down until the LED
flashes rapidly.
2. Press the INFO key. The LED stops blinking at this
point and stays on solid.
3. Press and release the C key. The remote is now in play-
back mode.
4. Observe the LED. The TV code will be indicated by a
blink sequence for each number. See example below.
1. Press the MUTE button and hold it down until the LED
at the top of the remote control flashes rapidly.
2. Press the FAV button. The remote is now in playback
mode.
3. Observe the LED. The TV code will be indicated by a
blink sequence for each number. See example below.