Setting the remote control id – Motorola RG2200 User Manual
Page 39
39
S
ETTING
THE
R
EMOTE
C
ONTROL
ID
Your NSP uses the following table when programming your remote control ID to work with each TV in your household. You
may use it, too.
To program the remote control ID:
Remote Control ID
Operates TV
Mode
0
Local TV1--TV in same room as RG. Remote is set to operate in IR mode.
IR
1
Remote TV1--TV in a different room than the RG.
UHF
2
TV2 (remote TV).
UHF
3
TV3 (3-stream models only).
UHF
SRC-300
SRC-200
1.
Press the LED key and hold it down until the LED
flashes rapidly.
2.
Press the REC key. The LED stops blinking at this point
and stays on solid.
3.
Press the A key. The remote is now in programming
mode.
4.
Enter the single-digit remote control ID from the table
on page 39.
1.
Press and continue to hold the A button until the LED at
the top of the remote flashes rapidly.
2.
Enter the following three-digit sequence: 7-8-9. The
remote is now in programming mode.
3.
Enter the single-digit remote control ID from the table
on page 39.