Motorola RG2200 - Manual (Page 71)

71
No power Power cord is disconnected. Check to make sure that the RG2200 is plugged into a live electrical outlet.
Note: If the outlet is controlled by a wall switch, make sure the switch is on.
VCR will not record VCR is on wrong channel. See “Changing Channels” on page 22.
VCR is programmed incorrectly. Refer to the VCR User’s Manual.
VCR is not connected properly. See “TV/VCR/Audio Connections” on page 59 .
VCR is connected with RCA
jacks and is not in correct mode. Place the VCR on the LINE input. This can be accomplished using the VCR menu or
changing the VCR channel until the display on the VCR indicates LINE.
Safety tab on tape is broken. Use a new tape.
VCR will not play tapes TV on wrong channel for play-
back or not using the correct
input. Tune TV to correct RF channel.
VCR is not connected properly. See “TV/VCR/Audio Connections” on page 59.
Amber On-line LED You don’t have on-line services. Call your Network Service Provider to initiate service.
Amber Network LED The Gateway is not ready for
use. Unplug power connection on back of Gateway then reconnect if light stays on more than
10 minutes.
Message on TV screen:
“There is a problem with the
network, Third video not
available.”
Or, you are unable to make
channel changes.
TV program temporarily not
available. Wait several seconds and try again. If you are still unable to make the channel change,
turn off one of the other TV programs by shutting off the TV with the remote. The
RG2200detects that the TV program is no longer being watched. This should free up
programming for the other TV and should allow you to receive video on the third TV.
Problem Possible Cause Try This