Metrologic Instruments MS7320 - Manual (Page 12)

8
I
NSTALLATION FOR
RS232
OR
L
IGHT
P
EN
I
NTERFACES
1. Turn off the host system.
2. Connect the PowerLink cable to the
10-pin RS232/Light Pen interface
jack. It is the 1
st
round opening from
the left side of the MS7320
(see figure 5).
3. Connect the other end of the
PowerLink cable to the host.
Before continuing verify that the
PowerLink cable is connected to the
appropriate interface jack on the
scanner. An incorrect cable connection
can cause communication problems or
potential damage to the scanner.
4. Connect the external power supply to
the power jack on the PowerLink
Cable.
5. Check the AC input requirements of
the power supply to make sure the
voltage matches the AC outlet.
6. Connect AC power to the
transformer. The outlet should be
near the equipment and easily
accessible.
7. Scan the appropriate bar codes on
page 9 to configure the MS7320 for
RS232 or Light Pen communication.
8. Turn on the host system.
9. Snap on the cable cover.
See SELV Power Source caution statement located on page 16 of this manual.
Figure 5: RS232 or
Light Pen Interface