Metrologic Instruments MS7320 - Manual (Page 22)

18
V
ISUAL
I
NDICATORS
There is a red LED and green LED on
the front of the MS7320. When the scanner is on, the
flashing or constant illumination of the LEDs indicates
the status of the current scan and the scanner.
Figure 12: LEDs
No Red or Green LED
The LEDs will not be illuminated if the scanner is not receiving
power from the host or transformer.
Steady Green
When the laser is active, the green LED is illuminated. The
green LED will remain illuminated until the laser is deactivated.
During the power save mode, the laser will turn on and off.
During this period, the green LED remains illuminated.
Steady Green and Single Red Flash
When the scanner successfully reads a bar code, the red LED
will flash and the scanner will beep once. If the red LED does
not flash or the scanner does not beep once, then the bar code
has not been successfully read.
Steady Green and Steady Red
After a successful scan, the scanner transmits the data to the
host device. Some communication modes require that the host
inform the scanner when data is ready to be received. If the
host is not ready to accept the information, the scanner’s red
LED will remain on until the data can be transmitted.
Flashing Green then Flashing Red
This indicates the scanner is in program mode. A razzberry
tone indicates that an invalid bar code has been scanned in
this mode.
or
If the unit is in sleep mode, each LED will flash once every 15
seconds.
Steady Red, Green off
This indicates the scanner may be waiting for communication
from the host.