Metrologic Instruments MS7320 - Manual (Page 14)

10
I
NSTALLATION FOR
IBM 46
XX
I
NTERFACE
1. Turn off the host system.
2. Connect the MVC cable to the 10-pin
IBM 46xx interface jack. It is the
1
st
round opening from the left side of
the MS7320 (see figure 6).
3. Connect the other end of the MVC
cable to the host.
Before continuing verify that the MVC
cable is connected to the proper
communication jack on the scanner.
Incorrect cable connection can cause
communication problems or potential
damage to the scanner.
Plugging the scanner into the
serial port of the PC does not
guarantee that scanned
information will appear at the
PC. A software driver and
correct configuration setting are
also required for proper
communication to occur.
4. Turn on the host system.
5. Scan
the Load 46xx IBM Defaults bar
code to configure the MS7320 for
RS232/IBM communication.
6. Snap on the cable cover
For additional communication
options for IBM interfaces refer to the
MetroSelect Configuration Guide
(
MLPN 00-02407).
See SELV Power Source caution statement located on page 16 of this manual.
³ 9 9 9 9 9 5
Load 46xx IBM Defaults
Figure 6: IBM 46xx Interface