Milan Technology MIL-W0311 - Manual (Page 19)

Wireless Gateway User Guide
16
WEP Status This will state "Enabled" or "Disabled".
The default is "Disabled".
• In order to use the Wireless Gateway's access point, the client
wireless stations must have the same settings for WEP.
• To change the Wireless Gateway's WEP settings, use the Wireless
screen, described in the following section.
Buttons
Save Save any data you have entered on this screen. Remember to save before
changing to another screen.
Cancel Cancel any changes you have made since the last "Save" operation.
Once this screen is completed, the Wireless Gateway is ready for use.
• If you wish to use WEP, or change other Wireless Access Point settings, refer to the
following section.
• Your PCs may require configuration. Refer to Chapter 4 - PC Configuration for details.
• To check the status of the Wireless Gateway, and confirm that it is working correctly, refer
to the Status Screen section later in this Chapter.