Milan Technology MIL-W0311 - Manual (Page 9)

Wireless Gateway User Guide
6
Reset Button This button has three (3) functions:
• Reboot. When pressed and released, the Wireless Gateway will
reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the diag-
nostic printing.
• Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The Wireless Gateway is now using
the factory default values.
PCMCIA slot Insert the supplied Wireless PCMCIA card into this slot.
• Ensure the power is OFF before inserting or removing the
PCMCIA Card.
• Do not use any other PCMCIA Card.
Power port (12V) Connect the supplied power adapter here.