Milan Technology MIL-W0311 - Manual (Page 27)

Wireless Gateway User Guide
24
WAN Status – PPPoE
If the WAN (Ethernet) port is using PPPoE, then clicking the WAN Status link on the Status
screen will reveal a screen like the following.
Figure 9: WAN Status – PPPoE
Status Data
WAN Status
Physical Address The "Hardware" address of this device, as seen by other devices on the
WAN.
IP Address The IP Address of this device, as seen by devices on the WAN.
(This device has 2 IP Addresses; one for the local LAN, and another
for the WAN port.)
Network Mask The Network Mask (Subnet Mask) for the IP Address above.
PPPoE Link
Status This indicates whether or not the connection is currently established.
If the connection does not exist, the Connect button can be used to
establish a connection.
If the connection currently exists, the Disconnect button can be used to
break the connection.
Connection Log
Log Data This shows status messages relating to the existing connection. The
most common messages are listed in the following table.