Milan Technology MIL-W0311 - Manual (Page 24)

Configuration
21
DHCP Table Use this link to view the IP Addresses which have been allocated to
LAN devices, or the Dial-in user, by the DHCP Server function.
The DHCP Table contains the following data:
• Port - The port which the DHCP client used to access this
device. Possible values are LAN, WLAN (Wireless LAN), and
RS232 (serial port).
• IP Address - The IP Address which has been allocated by the
DHCP server to the DHCP client.
• Physical (Hardware) Address - The Physical Address (Hard-
ware Address) of the DHCP client which has been allocated
this IP Address.
• Status - Possible Status values are "Leased" (the IP Address is
allocated to the device shown) or "Reserved" (the IP Address is
reserved for this device, but not currently allocated).
"Reserved" entries are generated for the Dial-in User, and for any
PCs for which an IP Address has been reserved. An IP Address can
be reserved for a particular PC using the Access Control - PCs
screen. The Access Control feature is described in Chapter 10.
System
System Data This is identical to the data shown on a "Diagnostic Printout", and
contains all system information.
Firmware Version The version of the firmware currently installed in this device.
Printer Status This shows the status of the printer. Click the "Refresh Screen"
button to update this information.
WAN Links
WAN (Ethernet)
Port View the WAN (Ethernet) status screen. This screen will vary
according to the connection method used (Direct connection or
PPPoE).
See the following sections WAN Status - Direct Connection and
WAN Status - PPPoE for details.
Serial Port Check the status of the Serial Port. This screen is also accessible
from the Serial Port sub-menu. See Chapter 6 - Serial Port for
details of this screen.
Access Control Log View details of connection attempts which have been blocked. See
below for more information.
Internet Access Log View details of outgoing connections to the internet. See below for
more information.