Milan Technology MIL-W0311 - Manual (Page 42)

PC Configuration
39
Other Unix Systems
For Internet Access via the Wireless Gateway
• Ensure the "Gateway" field for your network card is set to the IP Address of the Wireless
Gateway.
• Ensure your DNS settings are correct.
LPD Printing
To use LPD printing to the Wireless Gateway's printer, install an LPD printer using the stan-
dard procedure for your system.
• Use the Wireless Gateway's IP Address as the location of the remote host
• Use L1, L2, or L3 for the name of the printer on the remote host.
On the Wireless Gateway, the logical printers (L1, L2, and L3) can be configured on the
Options - Printer Port screen.
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Gateway's Access
Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the Wireless Gateway, each Wireless Station must have
compatible settings, as follows:
Mode The mode must be set to Infrastructure.
SSID (ESSID) This must match the value used on the Wireless Gateway. The default
value is
default
Note! The SSID is case sensitive.
WEP By default, WEP on the Wireless Gateway is disabled.
• If WEP remains disabled on the Wireless Gateway, all stations must
have WEP disabled.
• If WEP is enabled on the Wireless Gateway, each station must use
the same settings as the Wireless Gateway.