Milan Technology MIL-W0311 - Manual (Page 63)

Wireless Gateway User Guide
60
Delete Delete the entry selected in the drop-down list, regardless of whether its
details are shown on screen.
Update Update the entry selected in the drop-down list, using the data shown on
screen.
List All List all entries in the Routing table.
Save Save the RIP setting. This has no effect on the Static Routing Table.
Cancel Reverse any changes made since the last "submit" operation (i.e. since
clicking any other button).
Router Configuration
It is essential that all IP packets for devices not on the local LAN be passed to the Wireless
Gateway, so that they can be forwarded to the external LAN, WAN, or Internet. To achieve
this, the local LAN must be configured to use the Wireless Gateway as the Default Route or
Default Gateway.
Local Router
The local router is the Router installed on the same LAN segment as the Wireless Gateway.
This router requires that the Default Route is the Wireless Gateway itself. Typically, routers
have a special entry for the Default Route. It should be configured as follows.
Destination IP Address Normally 0.0.0.0, but check your router documentation.
Network Mask Normally 0.0.0.0, but check your router documentation.
Gateway IP Address The IP Address of the Wireless Gateway.
Metric 1
Other Routers on the Local LAN
Other routers on the local LAN must use the Wireless Gateway's Local Router as the Default
Route. The entries will be the same as the Wireless Gateway's local router, with the exception
of the Gateway IP Address.
• For a router with a direct connection to the Wireless Gateway's local Router, the Gateway
IP Address is the address of the Wireless Gateway's local router.
• For routers which must forward packets to another router before reaching the Wireless
Gateway's local router, the Gateway IP Address is the address of the intermediate router.