Microsoft PRO 906EX - Manual (Page 133)

Edit
125
4
❖ Back Margin: Top / Bottom
You can specify top and bottom margins on the back side of copies in Margin
Adjustment mode.
• Top
• Bottom
Default:
• Metric version: Top/Bottom 0 mm
• Inch version: Top/Bottom 0.0"
❖ 1 Sided → 2 Sided Auto Margin: TtoT
In 1 sided to 2 sided Duplex mode, you can specify the margins on the back
side.
The margin is set to the same value of “Back Margin: Left/Right".
• Left
• Right
Default:
• Metric version: Right 5 mm
• Inch version: Right 0.2"
❖ 1 Sided → 2 Sided Auto Margin: TtoB
In 1 sided to 2 sided Duplex mode, you can specify the margins on the back
side.
The value set for "Back Margin: Top/Bottom" is used.
• Top
• Bottom
Default:
• Metric version: Top/Bottom 0 mm
• Inch version: Top/Bottom 0.0"
❖ Creep Setting for Magazine
You can specify the creep binding margin width.
Range:
• Metric version: 0 to 99 mm (in increments of 1 mm)
• Inch version: 0 to 3.9 inch (in increments of 0.1 inch)
Default:
• Metric version: 5 mm
• Inch version: 0.2"
❖ Erase Border Width
You can specify the width for erasing border in the range of "2 to 99 mm" (in
units of 1 mm).
Default:
• Metric version: 10 mm
• Inch version: 0.4"