Microsoft PRO 906EX - Manual (Page 65)

Interface Settings
57
2
IEEE 1394
This section describes various items of [IEEE 1394] under [Interface Settings].
[IEEE 1394]
is displayed when this machine is installed with the IEEE 1394 inter-
face board (optional).
❖ IPv4 Address
When you connect the machine to a network using the IEEE 1394 interface,
you must configure the IP address and subnet mask.
When you select [Specify], enter the [Machine IPv4 Address] and [Sub-net Mask]
as “xxx.xxx.xxx.xxx”(“x” indicates a number).
When you use the IEEE 1394 interface on a network, you cannot use the Eth-
ernet interface in the same domain. To use both interfaces in the same do-
main, set different values for the [Sub-net Mask].
If you use the interface for Ethernet and IEEE 1394 (IP over 1394) at the same
time, settings must be made carefully.
• Auto-Obtain (DHCP)
• Specify
• Machine IPv4 Address: 000.000.000.000
• Sub-net Mask: 000.000.000.000
❖ DDNS Configuration
You can specify the DDNS settings.
• Active
• Inactive
❖ Host Name
Specify the host name.
Enter the host name using up to 63 alphanumerical characters.
❖ Domain Name
Make settings for the domain name.
• Auto-Obtain (DHCP)
• Specify
Enter the domain name using up to 63 alphanumerical characters.