Microsoft PRO 906EX - Manual (Page 60)

System Settings
52
2
Interface Settings
This section describes various items of [Interface Settings] under [System Settings].
Network
This section describes various items of [Network] under [Interface Settings].
❖ Machine IPv4 Address
Before using this machine in the network environment, you must configure
the IP address and subnet mask.
When you select [Specify], enter the [Machine IPv4 Address] and [Sub-net Mask]
as "xxx.xxx.xxx.xxx" ("x" indicates a number).
If you install the optional IEEE 1394 interface board and use the IEEE 1394 in-
terface, you must set the address of the domain, different from the [IPv4 Ad-
dress]
of [IEEE 1394]. If you intend to set the address for the same domain, set
a different value for the [Sub-net Mask].
When you select [Specify], be sure not to set the same [Machine IPv4 Address] as
that of another machines on the network.
The physical address (MAC address) also appears.
If you use the interface for Ethernet and IEEE 1394 (IP over 1394) at the same
time, settings must be made carefully.
• Auto-Obtain (DHCP)
• Specify
• Machine IPv4 Address: 011.022.033.044
• Sub-net Mask: 000.000.000.000
❖ IPv4 Gateway Address
A gateway is a connection or interchange point between two networks.
Configure the gateway address for the router or host computer used as a gate-
way.
• IPv4 Gateway Address: 000.000.000.000
❖ Machine IPv6 Address
You can specify the machine’s IPv6 network address.
• Link-local Address
The machine’s specified link-local address appears.
• manual Configuration Address
The machine’s manually configuration address appears.
• Stateless Address: 1-5
The specified stateless address appears.
❖ IPv6 Gateway Address
The machine’s IPv6 gateway address appears.