Moyer Diebel MD1000HT - Manual (Page 20)

14
1. Factory dispensers are
optional equipment; however,
an automatic dispenser must
be installed by someone in
lieu of the factory.
2. The dispensers are mounted on
the right-hand side of the lower
wash tank.
3. Chemical pick-up tubes are
inserted into their respective
containers.
4. Detergent and Rinse-aid chemical containers
can be placed a maximum of 11" [280 mm]
above the finished floor, (ABF).
5. Place the chemical containers as close
to the dishwasher as possible.
6. Each day check the detergent and rinse-aid
chemical containers to make sure they
are at least 1/2 full.
7. Push and hold the 2-position prime switch located on the front of the
top-mounted control cabinet. Push UP to prime the detergent
and DOWN to prime the rinse-aid.
8. Watch the chemical as it traveght-glass located on the
right-hand side, top-
rear corner of the
machine.
9. Release the switch
when the chemical
enters the sight-
glass.
10. Chemicals should
reach the sight-
glass within 2
minutes of prime.
Installation Guide _____________
;
Chemical Dispensers MD-1000HT
Priming the chemical dispensers
(Factory dispensers only)
MD-1000HT • Chemical Dispensers
Factory installed sight-glass
From
Chemical
Containers
To wash tank
injection points
IN IN OUT OUT