Moyer Diebel MD1000HT - Manual (Page 23)

17
_____________ Installation Guide
;
Initial Start-up MD-1000HT
MD-1000HT • Initial Start-up
POWER UP THE DISHWASHER:
As stated on page 15, the dishwasher power switch must not
be turned without reading the instructions below.:
13. Turn on the main power switch at the service disconnect switch.
14. Flip the dishwasher power switch UP to turn on the dishwasher.
15. Immediately, push the fill switch up and hold it in the up position
until the water flows out of the wash tank and into the lower scrap screen.
16. Release the fill switch.
17. Open the dishwasher door fully and check the water level inside the tank.
The proper water level is just below the overflow tube and 3" [76 mm]
from the lower sprayarm support. Measure from the back of the support
up the tank toward the rear wall of the dishwasher.
P O W E R O N CYCLE F I L L
D R A I N O F F
14 15
16
Water line
3" [76mm]