Moyer Diebel MD1000HT - Manual (Page 41)

35
_____________ Installation Guide
;
Initial Start-up MD-1000LT
MD-1000LT • Initial Start-up
POWER UP THE DISHWASHER:
1. Flip the dishwasher power switch UP to turn on.
2. Turn on the main power switch at the service disconnect switch.
3. Release the fill switch.
4. Open the dishwasher door fully and check the water level inside the tank.
The proper water level is just below the overflow tube and 3" [76 mm]
from the lower manifold measuring up the tank toward the rear of the
dishwasher.
Water line
5. Operate the dishwasher for 10 cycles
checking the temperature gauges to
ensure the machine is maintaining
the proper temperatures.
120°F/49°C minimum wash temperature
140°F/60°C recommended optimum
120°F/49°C minimum final rinse temperature
140°F/60°C recommended optimum
6. To drain the dishwasher, leave the machine
power switch in the ON position.
Doors are fully closed.
7. Push and hold the “FILL/DRAIN” switch down in
the “DRAIN” position for approximately 15-20
seconds.
8. The water in the wash tank will drain completely.
9. Open the doors and check that all water has
drained for the machine.
10. The initial start-up is complete.