Meyer Sound 616 - Manual (Page 33)

GALILEO 616 USER GUIDE
33
CAUTION: Be certain to remember the access code that has been used to lock
the Galileo front panel parameters from any changes. It must be entered cor-
rectly or changes will not be able to be made — and it will be necessary to contact
Meyer Sound Technical Services to obtain help with unlocking the unit.
Network Settings
Press the Enter button or the Blue or Green knob from System Settings to select this function.
Network Settings provides fields for device Nickname and for IP Type. Additional relevant
fields are offered for DHCP (dynamic) and Static IP addresses. Toggle between them with a
push of the Blue knob or the Enter button. The DHCP mode supports direct cable connection
between the computer’s Ethernet card and the Galileo 616. The DHCP will also reveal the
MAC address. This will display below the assigned IP address.
With either DHCP or Static IP, highlighting “Write Network Settings” and pressing Enter or the
Blue knob will load the settings and open a note saying “Writing Configuration”. “Reload Net-
work Settings” will load the IP address of the current server, and opens a note saying “Read-
ing Configuration” before writing those values into the provided fields. Static IP has fields for
IP Address, Net Mask, and Gateway, as well as Write Network Settings and Reload Network
Settings.
A utility is offered that allows an IP Address, Net Mask, and Gateway number to be created by
highlighting each of the four value positions, scrolling the Blue knob to the desired value, then
using the Right arrow to go to the next value position. For each of these fields, press Menu to
accept the changes, or Cancel to ignore the changes.
Network Settings Page
!