Motorola CAJUN P120 - Manual (Page 79)

Chapter 6 Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide 65
SNMP Configuration Group (SNMP)
This group includes parameters for the configuration of SNMP communities and
management stations to receive traps. The table below displays the Index values,
the parameter names, the community name, and their privileges.
To view or change these parameters, type the command set|show snmp list
at the prompt.
Table 6.16 SNMP Group Parameters
Index Value Parameter Community Name
16 characters max. Privileged
read and
write (rw) read only
(r)
Community 1 COMMUNITY public r
Community 2 COMMUNITY pl rw
Community 3 COMMUNITY null r
Community 4 COMMUNITY null r
Community 5 COMMUNITY null r
Index Value Parameter IP Address of IP Management Stations
Community 1 TRAP ______.______.______.______
Community 2 TRAP ______.______.______.______
Community 3 TRAP ______.______.______.______
Community 4 TRAP ______.______.______.______
Community 5 TRAP ______.______.______.______
COMMUNITY Allows you to change the list of community names and
Privileges. Up to 5 community names can be defined for the
Cajun P120.
TRAP Enter the IP address of each management station that you
would like to receive SNMP traps from the Cajun P120. Up to
5 trap managers can be defined.
If you would like the SNMP traps to display in the OpenView Alarm
Log, you should set the IP address and net mask of the OpenView
station under trap manager (community 1 trap).