Enable command, Show commands, Show ip route command – Motorola CAJUN P120 User Manual
Page 88: Show system command, Show ip route command show system command
Chapter 7
Cajun Campus CLI (Command Line Interface)
74
Cajun P120 User’s Guide
Enable Command
Enable Command
The
enable
command is used to enter the Privileged level. In Privileged level,
additional commands are available. The (enable) in the prompt indicates that the
system is in Privileged level and either Normal level or Privileged level commands
can be entered.
The syntax for this command is:
enable
Example:
Console> enable
Enter password:
Console>(enable)
Show Commands
Show IP Route Command
Use the
show ip route
command to display IP routing table entries.
The syntax for this command is:
show ip route
Example:
Console> show ip route
Console>
Show System Command
The
show system
command provides the following system information:
Destination
------------
Gateway
-------------
Interface
------------
0.0.0.0
172.20.22.201
ib1
console> show system
System-Up-Time : 0 Day(s), 1 Hour(s), 44 Minute(s), 39 Second(s)
MIB-II System-Name : CajunP120
MIB-II System-Contact : John-Smith
MIB-II System-Location : Atidim
console>