Motorola CAJUN P120 - Manual (Page 94)

Chapter 7 Cajun Campus CLI (Command Line Interface)
80 Cajun P120 User’s Guide
Show Cam Command
Use the show cam command to display the CAM table or a specific MAC.
The syntax for this command is:
show cam slot_num | port_num
show cam mac mac_addr [vlan]
Example:
To display dynamic CAM entries for all VLANs:
Console> show cam
Total Matching CAM Entries Displayed = 7
Console>
This example shows routers listed as the CAM entries. When the MAC address
belongs to a router, it is shown by appending an "R" to the MAC address. When a
VLAN is specified, only those CAM entries matching the VLAN number are
displayed.
Console> show cam mac 00-00-81-01-23-45
Total Matching CAM Entries = 1
Console>
vlan (Optional) Number of the VLAN. If a VLAN is not specified, all
VLANs are displayed.
slot_num Module number (always 1)
port_num Number of the port.
mac_addr MAC address.
VLAN
----
DestMAC/Route Des
-----------------
Destination Ports
-----------------
1 00-60-5c-86-5b-81 1/1
1 00-60-2f-35-48-17 1/1
1 00-80-24-f3-47-20 1/2
1 00-60-09-78-96-fb 1/1
1 00-80-24-1d-d9-ed 1/2
1 00-80-24-1d-da-01 1/2
1 08-00-20-7a-63-01 1/1
VLAN
----
Dest MAC/Route
--------------
Destination Ports
-----------------
1 00-00-81-01-23-45 1/9