Marathon MAGNUM ROUTER - Manual (Page 146)

Chapter 9: Sample Configurations
___________________________________________________________________
9-41
The only additional information needed is to program the route for the remote network into
Magnum B’s WAN IP Route Map table as shown below:
On Magnum A, RIP routing needs to be enabled. To do this, click on the WAN Config button,
then select the WAN IP Route Map button and finally the Advanced Routing button. The
following screen will be displayed:
In the upper right hand corner of this screen is a box to enable or disable RIP Version 1 routing.
Click on the box to add or remove the check mark signifying that RIP is enabled or disabled and
then click on Save followed by Exit.